![]() This is important so they don't catch on the material you cut. I drill holes for the 10-24 machine screws (3/16", I think) and then used a 1/2" drill bit to countersink the hole so that the screw head and washer fit below the surface. Now that I had an idea where the body of the saw wanted to be, I used the saw's cut guard as a template for the screw holes. It works pretty well, except that small slivers of wood can get caught in between the blade and the base. My thought was to essentially make a 'zero clearance' guide to keep the blade as straight as possible. I then used the portaband to cut the slit for the saw blade. I used a speed square to draw the lines and a circular saw to cut them. I started by notching the plywood to fit the base of the saw. If your serial number lies between these two values then all we can say is that your saw dates from 1941 or '42. Straight Numerical Series used by Milwaukee-Crescent The strange jump from 15-0000 to 16-0000 is in the original. The following is based on this original document. Any rigid ply with a smooth side should work fine. These machines would have been built in Milwaukee, Wisconsin up to 1952. The base is a scrap piece of 3/4 birch plywood-the cheap (quality) stuff found at Home Depot.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |